
ZN110HL Installation Guide
Page 5
3
4
1
2
New Construction Installation
5
Connect Wires and Install Knockout Plate
• Run 120VAC electrical wiring to the installation location.
• Use proper UL-approved connectors to secure wiring to the Knockout Plate provided in Parts Bag.
• Connect wires as shown in wiring diagram.
• Do not use a dimmer switch to operate the light.
Screw from
Parts Bag
Attach cable clamps to Knockout
Plate. Knockout Plate mounts to
outside of Housing and may be
oriented as desired.
Connect wires
Fan
Light
LIGHT
WHT
MANUAL-ON
GRD
WHT
BLK
GRD
WHT
BLK
RED
120 VAC
LINE IN
MULTI-FUNCTION
WALL SWITCHES
SENSOR/CONTROL
MASTER
LIGHT
NIGHT
LIGHT
FAN
SENSOR/
CONTROL
BLK
WHT
BLK
BRN
BLU
NIGHT
LIGHT
RED
ORG
WHT
BLK
RED
BLU
RED
14/4
(IF ALL
WALL SWITCH
OPTIONS
ARE USED)
14/3
KNOCKOUT
PLATE
LIGHT RECEPTACLE WIRES
FAN RECEPTACLE
WIRES
MULTI-FUNCTION
WALL CONTROLS
(purchase separately)
120 VAC
LINE IN
MANUAL - ON
MASTER
SWITCH
BOX
LIGHT
NIGHT
LIGHT
SENSOR / CONTROL
BLACK
WHITE
ORANGE
RED
BLUE
GROUND
(green or bare)
BROWN
RECEPTACLES
• See OPERATION
section on page 12 for
details.
• MASTER switch
turns fan system on
and shuts it off for
fan cleaning and
maintenance purposes.
• SENSOR/CONTROL
switch turns humidity
control automatic
operation on/off.
• MANUAL-ON switch
directly increases fan
operation to certified
airflow rate.
• MASTER switch must
be on for humidity
control or MANUAL-ON
switch to change fan
operation to certified
airflow rate.
• MANUAL-ON switch is not required
to manually increase fan operation to
certified airflow rate (see page 10).
• MASTER and SENSOR/CONTROL
switches can be combined (see page
10).
• MASTER switch along with or
separate from SENSOR/CONTROL
switch may be located where they
are not easily accessed for everyday
usage; they may need to be labeled
and located where they can’t be turned
on without being seen from fan to
comply with local and national codes.
Komentarze do niniejszej Instrukcji